Conditional execution in Thumb state
To execute Thumb instructions conditionally, you can either use an
IT instruction, or a conditional branch instruction.
In Thumb state on processors before ARMv6T2, the only mechanism for conditional execution is a conditional branch. You can conditionally skip over the instruction using a conditional branch instruction.
In Thumb state on ARMv6T2 or later processors, instructions can also be conditionally executed by using any of the following:
CBZ (Conditional Branch
on Zero) and
CBNZ (Conditional Branch
on Non-Zero) instructions compare the value of a register against
zero and branch on the result.
IT is a 16-bit instruction that enables almost all Thumb instructions to
be conditionally executed, based on the value of the condition flags and the condition code
suffix specified. Each
IT instruction provides conditional execution for up
to four following instructions.
Conditional instructions using IT block
; flags set by a previous instruction ITT EQ LSLEQ r0, r0, #24 ADDEQ r0, r0, #2 ;…