You copied the Doc URL to your clipboard.

--largeregions, --no_largeregions

This option controls the sorting order of sections in large execution regions to minimize the distance between sections that call each other.


If the execution region contains more code than the range of a branch instruction then the linker switches to large region mode. In this mode the linker sorts according to the approximated average call depth of each section in ascending order. The linker might also place distribute veneers amongst the code sections to minimize the number of veneers.


Large region mode can result in large changes to the layout of an image even when small changes are made to the input.

To disable large region mode and revert to lexical order, use --no_largeregions. Section placement is then predictable and image comparisons are more predictable. However some branches might not reach the target causing the link step to fail. If this happens you must place code/data sections explicitly using an appropriate scatter file or write your own veneer.

Large region support enables:

  • average call depth sorting, --sort=AvgCallDepth

  • API sorting, --api

  • veneer injection, --veneerinject.

The following command lines are equivalent:

armlink --largeregions --no_api --no_veneerinject --sort=Lexical
armlink --no_largeregions


The default is --no_largeregions. The linker automatically switches to --largeregions if at least one execution region contains more code than the smallest inter-section branch. The smallest inter-section branch depends on the code in the region and the target processor:


Execution region contains only ARM.


Execution region contains Thumb, 32-bit Thumb is supported.


Execution region contains Thumb, no 32-bit Thumb support.