You copied the Doc URL to your clipboard.

--max_veneer_passes=value

This option specifies a limit to the number of veneer generation passes the linker attempts to make when both the following conditions are met:

  • a Section that is sufficiently large has a relocation that requires a veneer

  • the linker cannot place the veneer close enough to the call site.

The linker attempts to diagnose the failure if the maximum number of veneer generation passes you specify is exceeded, and displays a warning message. You can downgrade this warning message using --diag_remark.

Syntax

--max_veneer_passes=value

Where value is the maximum number of veneer passes the linker is to attempt. The minimum value you can specify is one.

Default

The default number of passes is 10.

Was this page helpful? Yes No