When you want to modify specific bits in a system register, you must ensure that you do not modify the other bits in the same register. This is because individual bits in a system register control different system functionality, and modifying them might cause your program to behave incorrectly. You must use a read-modify-write procedure to ensure that you modify only the bits you want to change.
To read-modify-write a system register, the instruction sequence must be:
The first instruction copies the value from the target system register to a temporary general-purpose register.
The next one or more instructions modify the required bits in the general-purpose register. This can be one or both of:
BICto clear the bits that must be cleared to 0.
ORRto set the bits that must be set to 1.
The final instruction writes the value from the general-purpose register to the target system register.
This example shows the read-modify-write procedure to change some bits of a SIMD and floating-point system register, FPSCR without affecting the other bits.
VMRS r10,FPSCR ; copy FPSCR into the general-purpose r10 BIC r10,r10,#0x00370000 ; clears STRIDE bits[21:20] and LEN bits[18:16] ORR r10,r10,#0x00030000 ; sets bits[17:16] (STRIDE =1 and LEN = 4) VMSR FPSCR,r10 ; copy r10 back into FPSCR