DCPS2 (T32 instruction)
Debug switch to exception level 2.
NoteThis instruction is supported only in ARMv8.
This instruction is valid in Debug state only, and is always UNDEFINED in Non-debug state.
DCPS2 targets EL2 and:
- If EL2 is using AArch32, the PE enters Hyp mode.
- If EL2 is using AArch64, the PE enters EL2h, and executes future instructions as A64 instructions.
In Non-debug state, use the
to generate a trap to EL2.
This 32-bit instruction is available in T32 only.
There is no 16-bit version of this instruction in T32.