DCPS3 (T32 instruction)
Debug switch to exception level 3.
NoteThis instruction is supported only in Armv8.
This instruction is valid in Debug state only, and is always UNDEFINED in Non-debug state.
DCPS3 targets EL3 and:
- If EL3 is using AArch32, the PE enters Monitor mode.
- If EL3 is using AArch64, the PE enters EL3h, and executes future instructions as A64 instructions.
In Non-debug state, use the
to generate a trap to EL3.
This 32-bit instruction is available in T32 only.
There is no 16-bit version of this instruction in T32.