You copied the Doc URL to your clipboard.

Dual cluster system configuration block parameters

You set these instantiation-time parameters when starting the model.

The syntax to use in a configuration file or on the command line is:

coretile.dualclustersytemconfigurationblock.parameter=value

Table 3-21 Dual cluster system configuration block parameters

Parameter Type Allowed values Default value Description
CFG_ACTIVECLUSTER int 0x1-0x3, bit mask 0x1

Select the cluster that comes out of reset at power on:

Bit[0] For the Cortex®‑A15.
bit[1] For the Cortex‑A7.
Cluster0IdOnPOReset int 0x0-0xF 0x0 Cortex‑A15 Cluster ID on power-on reset.
Cluster1IdOnPOReset int 0x0-0xF 0x1 Cortex‑A7 Cluster ID on power-on reset.
DCS_LED bool 0x00-0xFF 0x00 Initial value of the DCS_LED register that represents the state of the daughterboard LEDs.
ResetValueOfDaughterUserSwitches int 0x00-0xFF 0x00 The state of the daughterboard user switches at reset.
INTGEN_INTS int 0-3 3 Number of custom IRQs that the interrupt generator controls is (INTGEN_INTS × 32) + 32.
DCS_ID int 0x0-0xFFFFFFFF 0x41120000 The value returned by the DCS_ID register.
FlipVGICWiringForCluster0AndCluster1 bool true, false false
true If this is true, then core 0 of cluster 1 becomes core interface 0 on the GIC-400.
false If this is false, then core 0 of cluster 0 becomes core interface 0 on the GIC-400.
Was this page helpful? Yes No