Getting Started with the UltraScale+ and Arm DS


Overview Set up the ZCU102 Set up the Ultra96 Running Code Next steps

Set up the ZCU102

  1. Connect the DSTREAM or ULINK to J6, the Arm 20 pin JTAG connector.
  2. Connect a micro USB to the USB UART port J83, this will show up as 4 COM ports on the host PC. The serial config options are 115K 8N1.
  3. Jumper links should be left in their default positions, ensure J14 is closed (see jumper section in the Xilinx manual).
  4. Connect the 12V Power Supply.

It is possible to boot the target in different modes, boot from an SD card, JTAG boot mode or QSPI32. If you have a linux kernel image you would like to use, you can load that on a SD card and boot from it. If you would like to flash your own image into RAM you can boot in JTAG mode. 

Previous Next