Enea NFV Access offers developers a best-in-class virtualization and management platform for any Arm-based universal or virtual customer premise equipment (uCPE or vCPE). Developers bring their own SD-WAN, vFirewall, vRouter, LTE or 5G, or any other virtual network function (VNF) solution to this platform.
Enea NFV Access is a complete network function virtualization infrastructure (NFVI) platform, optimized to reduce cost for communication service providers (CSPs) and small to medium-sized enterprises (SME). Enea NFV Access efficiently scales across Arm-based uCPE and vCPE boxes with a wide range of uCPE and vCPE configurations. To reduce administration and maintenance costs, Enea NFV Access provides developers with support for Zero Touch Provisioning (ZTP) and Automation.
High performance low footprint advantage
Enea NFV Access depends on the NETCONF protocol, reducing the footprint and resource utilization to a minimum and optimized for Arm chipsets. Based on open interfaces and open protocols, Enea NFV Access guarantees a fully lock-in free software platform.
Enea NFV Access Partner Ecosystem
Enea NFV Access is supported by a strong developer ecosystem including hardware vendors, VNF developers, and orchestration solution providers.
Expert insight: Ampere Computing
Interview with Jeff Wittich at Ampere Computing about optimized processor and virtualization platforms for the Edge.
|Answered||Which ARM micro controller should I choose?||0 votes||720 views||4 replies||Latest 5 days ago by raj_99||Answer this|
|Not answered||Cortex-M0+ core Hang up in FFFF FFFEh address when executing DSB instruction.||0 votes||62 views||0 replies||Started 9 days ago by Ponsuke606||Answer this|
|Suggested answer||How to get/download core_cr5.h||0 votes||196 views||1 replies||Latest 23 days ago by hulk789||Answer this|
|Not answered||After first execution control goes to task 2 but i want him to go to task1 what i suppose to do here?||0 votes||121 views||0 replies||Started 25 days ago by omkardixi||Answer this|
|Not answered||How to change baud rate using UART during run time?||0 votes||151 views||0 replies||Started 27 days ago by omkardixi||Answer this|
|Not answered||reliability of Arm processors||0 votes||137 views||0 replies||Started a month ago by Ethan ZK||Answer this|
|Answered||Which ARM micro controller should I choose? Latest 5 days ago by raj_99||4 replies 720 views|
|Not answered||Cortex-M0+ core Hang up in FFFF FFFEh address when executing DSB instruction. Started 9 days ago by Ponsuke606||0 replies 62 views|
|Suggested answer||How to get/download core_cr5.h Latest 23 days ago by hulk789||1 replies 196 views|
|Not answered||After first execution control goes to task 2 but i want him to go to task1 what i suppose to do here? Started 25 days ago by omkardixi||0 replies 121 views|
|Not answered||How to change baud rate using UART during run time? Started 27 days ago by omkardixi||0 replies 151 views|
|Not answered||reliability of Arm processors Started a month ago by Ethan ZK||0 replies 137 views|